Page 1 of 1
Sphere detection RMS threshold
Posted: Fri Jan 29, 2016 12:15 pm
by rdurr
We use the sphere detection option in the point pair picking registration tool. Our scanning device has relatively high range noise and we often get a
[ccPointPairRegistrationDlg] RMS is too high! message.
Is it possible to change the RMS threshold value?
Re: Sphere detection RMS threshold
Posted: Fri Jan 29, 2016 8:24 pm
by daniel
Good idea. I added a new field to the Align tool. You can download the latest beta version online to test this (should be ready in a few minutes).
Re: Sphere detection RMS threshold
Posted: Fri Jun 03, 2016 9:56 am
by Maren
I´d like to use the sphere fitting by a given radius. Might this be possible?
Re: Sphere detection RMS threshold
Posted: Fri Jun 03, 2016 11:10 am
by daniel
Not right now. I know someone had hacked the qRansacSD tool to add a constraint on the sphere radius, but he has never sent me the code :(
It was not very hard if I believe him.
Re: Sphere detection RMS threshold
Posted: Tue May 29, 2018 2:25 am
by sylvain gautier
Hi Daniel,
Do you have some update about sphere fitting since 2016? I can see on tool-fit-sphere an automatic algorithm but I would like to give a specific radius.
Best regards,
Sylvain Gautier
Re: Sphere detection RMS threshold
Posted: Tue May 29, 2018 5:33 pm
by daniel
It doesn't seem someone was motivated enough to do this (even though it shouldn't be too complicated - I say that in case you have some minimal development skills ;).