CloudCompare forum

I usually manually correct the automatic segmentation before to fit the grains by ellipsoid. Doing so, I created (by mistake) a grain with only 2 points. When I try to fit the grains, CloudCompare crashes without any warning. Could it be possible to stop the process before the crash or to ignore grains that are too small ?
I use Cloud Compare V2.14.Alpha (installed 04/25).
Thanks a lot !

Hello
My guess is that the fitting algorithm expects a minimum number of points and runs into trouble when it encounters a grain that small. A simple safeguard to ignore undersized grains would make sense. In the meantime, you might want to consider filtering out very small grains before running the fit.